
BM 970
Year of commercialization: 2012
I have a problem
The screws are loose
=> Tighten all visible screws
Lack of lubricant
=> Lubricate the joints and the two weight guiding tubes with silicone spray
Assembly problem
=> Check that the pulleys have not been over-tightened
=> Check that the cables haven't get out of the pulleys
=> Check that the cables have been mounted as per the assembly instructions
Assembly problem
=> Untwist the cables and lay them on the ground. Then re-assemble the cables without twisting them.
The batteries are not properly mounted
=> Check that the batteries are properly mounted
The batteries are dead
=> Replace the batteries
The cables are not properly connected
=> Make sure the cables are properly connected
Problem with the position of the sensor on the weight guide tube
=> Check that the sensor is on the top part of the bracket and turned towards the magnet
=> Check that the magnet faces the sensor as shown below
Wrong assembly of the 2 pulleys
=> Assemble the plates as shown on the picture with the screws at the 2 ends
The screws are too tight
=> Loosen the screws

Look for the part number and click on 'NO’