VM ESSENTIAL 2

2112656

Year of commercialization: 2016

I have a problem

MY CONSOLE DOESN'T COME ON

 

Your bike works with batteries
 
 
                        1/ Remove the console from stand and place 2 AAA bateries in the specially designated compartment at back of screen.
 
                        2/ Ensure that the batteries are inserted correctly and are in full contact with the springs.
 
                        3/ If the display is unreadable or incomplete, remove the batteries, wait fifteen seconds and put them back.
 
                        4/ If the problem persists, start again with new batteries.

 

 

 

 
 

MY CONSOLE REMAINS ON ZERO

Check that the cables are correctly connected behind the console and where the bracket joins the main frame of bicycle.

 

MY CONSOLE DOES NOT INDICATE THE RIGHT UNITS OF MEASUREMENT FOR THE DISTANCE

 

1- Make sure the switch on the rear of the console is on \"Km\" for a display in kilometres and \"Mi\" for a display in miles
 
2- Make sure the switch on the rear of the console is on \"VM\" for an exercise bike and \"VE\" for a cross trainer
 
3- Remove and replace a battery to reset the console

I CAN'T FIT THE PEDALS

 

The right pedal (R) and the left pedal (L) do not screw on in the same direction:

 

 

 

 
 

THERE'S A CLICKING NOISE WITH EACH TURN OF THE PEDALS

Unscrew the pedals by one turn, then screw them back on very tightly

 

 

MY BIKE MAKES A NOISY

Tighten all visible screws

 

 

I HAVE A PROBLEM WITH THE RESISTANCE

 

Unscrew the handlebar bracket tube and check that the cable connection has been made correctly 

Make sure the black shim on the lower part of the cable has been removed

 

PROBLEMS MONITORING HEART RATE

 
1-Check the connection of the connector coming out of the handlebars
2-Moisten your hands slightly and place both hands on the sensors
 

MISSING OR BROKEN PART

Look for the part number and click on 'NO’

 

MAINTENANCE

1. Unplug the adaptor after each use.

 

2. Clean with a soft, slightly damp cloth after each use.

 

3. Regularly check against the instructions that your bike is stable and that the screws are tight.

 

4. If you aren't going to use your bike for a while:

- remove the batteries

- don't leave your bike in direct sunlight or anywhere damp

Manual and software

HAUT DE PAGE